• Welcome to SVTPerformance!

1993 Ford Mustang SVT Cobra Fully Built

Discussion in 'Fox-Body Cobras' started by exrider416, Jul 18, 2020.

  1. exrider416

    exrider416 Member Established Member

    Messages:
    62
    Joined:
    Apr 15, 2007
    Location:
    cincinnati
    1993 Ford Mustang Cobra
    60+k original miles
    Leather interior and sunroof
    1 of 1009
    8.2 Dart Iron Eagle (347 Probe Rotating Assembly, 8.5:1 compression ratio, Custom Ground Turbo Cam, Crower Tie Bar Lifters, Hardened Pushrods, 1.6 Harland Sharp Roller Rockers, O-ringed block)
    AFR Renegade 220 Heads
    Edelbrock Super Victor EFI Intake w/105mm Wilson Throttle Body
    FIC 1300 Injectors
    Holley Dual Sync Distributor
    MSD BTM Ignition System ( Knob is zero’d out as all timing is done in Holley Ecu)
    4 Core Aluminum Radiator
    Stainless On3 Turbo kit w/ Precision Gen2 7675. Also has Precision 44m Wastegate with Dome Pressure Sensor for boost control.
    Performance Automatic AOD-E w/Lock-up convertor and transbrake
    Derale Dual Fan Trans-cooler
    Stifflers Crossmember & DS Safety Loop
    Chromoly Driveshaft 1350 joints and Strange Strange Moly Yoke
    Holley HP ECU (Beside all the basic sensors, it has: Mac Dual Boost Solenoids, Ethanol Content Sensor, Dome pressure sensor)
    Holley 7” Digital Dash
    Snow Performance Meth System (I used a Holley output to turn the pump on at certain parameters)
    Nitrous bottle mounted is trunk is not hooked up and has never been, I do have the solenoid valves and line for it though.
    2.5lb Co2 tank and regulator for boost control
    Behind bars racecars fuel tank w/ Protuner 750 intank pump (10an supply to Earls Filter and then 8an to front of car/ 8an Return line)
    Full tubular kmember and front suspension with Strange single adjustable coilovers
    Wilwood Front brakes w/Racecraft Drop Spindles
    8.8 Rearend welded and braced, 35 spline gun-drilled axles, 3.55 gear, Strange Moly Pinion Yoke.
    Single adjustable Strange Coilovers in rear
    QA1 Lower controls arms/Bmr Adjustable uppers
    Welds RTS s71 Wheels (15x10s/15/4.5) Currently on slicks and cheap front tires, have brand new mickey thompson s/r fronts and Radial R's for the back.

    Car is extremely clean!! Underbody & Interior are a 9-10. Exterior is around an 8, some very small imperfections from a previous re-spray.

    I’m sure I missed some stuff as well

    Would possibly trade for a Boosted Coyote car or Coyote swapped car or/ something of equal value.

    Car should go in the dyno in the next couple weeks. Should not have an issue making 1000whp or going 8's once dialed in.

    $37k OBO










    Imgur
    Imgur
    Imgur
    Imgur
    Imgur
    Imgur
    Imgur
    Imgur
    Imgur
    Imgur
    Imgur
    Imgur
     
  2. bradleybonifaci

    bradleybonifaci Member Established Member

    Messages:
    37
    Joined:
    Jun 29, 2016
    Location:
    Knoxville
    Great looking car but I’m looking for one that’s closer to stick
     
  3. 03cobra#694

    03cobra#694 Want to play a game? Staff Member Super Moderator

    Messages:
    51,356
    Joined:
    Aug 12, 2008
    Location:
    SW FL.
    Do you mean stock?
    Nice car OP.
     
  4. exrider416

    exrider416 Member Established Member

    Messages:
    62
    Joined:
    Apr 15, 2007
    Location:
    cincinnati
    Car is getting dyno tuned on Thursday. So I should have actual power #
     
  5. exrider416

    exrider416 Member Established Member

    Messages:
    62
    Joined:
    Apr 15, 2007
    Location:
    cincinnati
    The car made over 700 on 15psi at 5500rpms when a coupler busted. After we fixed this the car developed a manifold leak on the passenger side. Which was giving the wbo2 a “false lean” and adding fuel. We decided to end the session at that point. Fuel tables looked great throughout the pull.
    The car currently needs the drivers manifold leak fixed! It will drive fine if you go to open loop. I am frustrated with the car and willing to take offers
     
  6. collibr1

    collibr1 Member Established Member

    Messages:
    434
    Joined:
    Nov 19, 2004
    Location:
    FLORIDA
    You have a beautiful car with a ton of nice parts. You might want to reduce the price to what you are willing to take. The advertised price might be scaring potential buyers off. It will also help reduce the lowball offers as well. Just some food for thought.
     
    gt347mustang likes this.
  7. exrider416

    exrider416 Member Established Member

    Messages:
    62
    Joined:
    Apr 15, 2007
    Location:
    cincinnati
    Trans is going in a new case. Car will be back together shortly
     
    Last edited: Aug 3, 2020
  8. CobraBob

    CobraBob Authorized Vendor Premium Member Established Member

    Messages:
    91,637
    Joined:
    Nov 17, 2002
    Location:
    Cheshire, CT
    Sorry to hear you've run into issues. Very nice looking Cobra. Hope all goes well with the car and with a sale.
     
  9. exrider416

    exrider416 Member Established Member

    Messages:
    62
    Joined:
    Apr 15, 2007
    Location:
    cincinnati
    Transmission is being pulled today and probably to the trans shop this week
     
    Loosescrews likes this.

Share This Page