2.93 to 2.76 swap - timing and a/f question

[me32]

Alright, super stoked! I downloaded livelink 6.5 from that link above and after deleting anything sct related from my laptop, I was able to get my xcal 2 to connect. I then played with it for a while and was able to get it to read my car! I will be able to use it for data logging. Super excited!

Thank you both for your help!

Glad to hear bud.

 

[01yellercobra]

I do! It’s a dynojet wideband commander. I know how to data log with that separately but tying the two together will be ideal! Going to have to figure all of that out now.

You'll need a round serial cable. The wideband should have a 0-5v output. You'll have to figure out which pin on the cable matches analog 1 on the Xcal2 aux plug. Connect the 0-5v output to that wire on the serial cable.

Something you'll have to figure out is if you need to wire a ground through the serial cable. I used to run a PLX and it didn't need a separate ground for the datalogging. But when I wired a buddies Autometer wideband it needed that extra ground wired through the cable.