Were or what would be a good place to get the power from?
I used the defroster wire(pink w/blue stripe) make sure you use a fuse,or you could find a switched circuit at the fuse box.
Were or what would be a good place to get the power from?
Motherf%#$ this has been a pain the ass, all day!
Guys, I need help finding out where the short, white 12V wire goes. The diagram says 12+ Volts Dash Lighting, but doesn't say where to splice it in to on the Dash Lighting Module.
I also broke a 1/4" drive in my burp plug, as many of you have. I'm using vice grips now, but I'm wondering if it's reversed threaded. If I'm standing on the driver's side if the engine bay, am I turning left or right?
It`ll go to fuse #37(dash light dimming),and it`s a standard thread,not reversed.
I've already wired my red/white/blacks to both add-a-circuits and ground. This one is about 12" long and splices to one of the wires in the dash lighting module itself. There are 10-12 different colored wires that connect to the module and I need to splice into the one that will backlight the new gauges. Blue/White?
Connect both white lighting wires and grounds together.
Okay, I can do that, but are you asking me to t-splice in to the other two whites from both gauges that run to fuse #37?
On the diagram above, I'm talking about the (2) bottom dash lighting wires, these are only approx. 12" long, at best. They won't reach the fuse box.
This is a great write up!!! But I had a couple questions..
When you click on the link for the gauge pillars, the 3rd picture down it shows a picture that was took in the dark to show how bright and great looking the gauges are.
My question is....that to me looks very stock. It matches the car almost perfect. The neon green light looks just like my light on my console.
So is it just preference on what color to pick with your gauges?
I want mine to look stock to the fullest.
Also there are many different choices on what gauges to buy.
What is the most common A/F and Boost or Fuel ?
Thanks guys great write up again!
Also How did you get the SVT Logo on the actual Gauges????? Thats looks so sick!!!!
How come when I did my water temp gauge and oil pressure gauge, followed the instructions to the T, and now when I start my car, it takes at least 5 seconds for the stock gauges on my dash to turn on?
How come when I did my water temp gauge and oil pressure gauge, followed the instructions to the T, and now when I start my car, it takes at least 5 seconds for the stock gauges on my dash to turn on?
12. Marry the red line from each harness and connect it to the other add-a-fuse and pull the 15 amp fuse from fuse #5, replace the original fuse spot with the add-a-circuit and put original in slot of add-a-fuse…now put a new 10 amp fuse in the other slot of the add-a-circuit; Fuse #5 is for power
So there are two fuses now in the add-a-fuse: the original 15amp one from slot #5, and a new 10amp one?