in theory that makes scence BUT the blower is made to with stand everything installed per stieg. it should be at 550rwhp...
in my limited knowledge...all signs point to blower inefficeincy. too hot. solution....whipple or kb.
yepperzzz sent all them and still cant figure it out. pulled everything checked it over and reinstalled and still runs same... so im at a loss as to that it could be... the only thing i can think of is covering the silencer holes with jb weld on the blower but that shouldnt affect any performance... even checked to see if the jb was stopping the rotters from turnin but it was clean and clear
feels like a fuel issue bc then i floor it it takes a few sec to go... its not instant and when shifting 1st to 2nd has about a second or 2 the the car is floored and nothin is happenin, to me it feels like not gettin enough fuel almost like BAP isnt workin but on the datalogs it shows it is and even getin up to 70% duty cycle
??? if you go over 70-75 you need to replace pumps and run twin gt pumps, that was my understanding??
The blower is fine at that boost level, his power loss isn't from the blower being too hot. To give any sort of help we'd need to see some datalogs.
BTW Whipple and KB run extremely hot also, you'd be suprised how close the charge temps are to the Eaton
LOL so should you with 500hp, I ran a 12.1 with a bolt on ls1.....
ahh... i can increase up from 40% or its in tune ;/