What Maf housings did you guys go with?
I used a 83mm VMP tube, which equates to 3.5"
What Maf housings did you guys go with?
I used a 83mm VMP tube, which equates to 3.5"
The fix is either to weld another bracket to it that bolts to the drivers side head. Then still are limited on pulley selection, or run the bracket like encased metal did.
Does anyone know the biggest size 6-rib pulley you can run with the standard procharger bracket?
That may be the worst logic I've ever heard. Sorry, but wow. Good luck I suppose.
It's the Metco 6lb pulley, which they list as being 9.1".How are you measuring the crank pulley to get 9.1"? My 18% OD pulley is 7.75" the stock size is 6.5".
Are you trying to run the lower pulley off an 03/04?
Not sure what you're asking. I'm currently running the metco 6lb crank pulley on an 03 cobra, which Metco lists as being 9.1" in diameter. Stock size is approximately 7.5". I'm wondering what the largest size 6-rib pulley I can put on an F1 without any issues and also what size should generate 16-18psi.