Hello,
i need help.
How much weighs the new Oliver I-Beam with ARP Bolts?
Ralf
i need help.
How much weighs the new Oliver I-Beam with ARP Bolts?
Ralf
Last edited:
Nobody?
Sorry, I have the Oliver rods in my motor, but don't have the weight, I'm not even sure who balance my rotating assembly would have the weights. I looked it up this morning on Oliver web site but the weights were not listed, you should call them or email them Monday, again sorry. Bill
Yes, that is what I paid for my rods, I also upgraded the ARP 7/16 WSB bolts that come with them to ARP's MP35X for a addition $400. You may ask them if they are needed for your build, I was looking for a higher rev, more boost motor. Your English is fine, I have another friend over there his name is Ralf also. Good Luck, BillThanks Bill,
you are my hope.:beer:
I have read your post from your Motor, I congratulation.
I can to have the Oliver Rods for $1300, that is the good price.
Ralf
When finished my Motor, i can english.:read:
Yes, that is what I paid for my rods, I also upgraded the ARP 7/16 WSB bolts that come with them to ARP's MP35X for a addition $400. You may ask them if they are needed for your build, I was looking for a higher rev, more boost motor. Your English is fine, I have another friend over there his name is Ralf also. Good Luck, Bill
You are correct again, he is a good man, if you speak to him say I said hello! BillHey Bill,
your another friend is Ralf Kli...., or also Bandit 012?
My new motor for 93 octan:
Ford GT-Block
Oliver I-Beams?
Manley 18 Dish Pistons Skit Coated
Ported Ford GT Heads
Bronze Valve Guides
Ford GT-Camshafts
Whipple 3.4 with 3.5 or 3.25 Pulley
IW-10%Pulley
80 Injektors FRPP
BAP Dual-Kenne Bell
L&M 66 dual bore TB
MAF Housing 123mm or 125mm MAF selfmade
Air-Filter from FRPP
CAI House from 4.6 Bullitt rebuilt
HPX Sensor
Waes from Snow with 5 Gallon Tank selfmade?
Clutch?
JBA-Longtube Headders Cc.3“X-Pipe with Cats and Axle back
HE-AFCO
Ralf
You are correct again, he is a good man, if you speak to him say I said hello! Bill
i cant read that. it hurts my head.
i would suggest getting custom grind cams instead of the ford GT cams. you'll get more bang for your buck since they'll be tailored to your new engine set up.
Cams are a waste of money!!! Up your compression!!!
Cams are a waste of money!!! Up your compression!!!
Cams are a waste of money!!! Up your compression!!!
i cant read that. it hurts my head.