new parts that im selling Only reason I can't return them is because they sat around for too long and they wont accept returns for them. All parts are FREE shipping and BRAND NEW. All parts for 03-04 Cobra some may fit other models also.
Maximum Motorsports Caster Camber Plates - 200
Drop...
I have bad steering issues and bumpsteer problems. Im not sure how to approach this whether it be with a bumpsteer kit or CC plates. After searching all over the forums it seems like most people with stock ride height average around 27 3/4 inches from the ground to fender and 28 1/4 inches from...
my steering wheel has had a lot of play about 2 inches atleast side to side where i can turn the wheel without the tires moving. I checked the shaft and joints and there were no issue so i decided to remove the airbag and see if it was the steering wheel itself and sure enough it was. the nut...
ive put tons of miles on my 03 cobra after reflashing the computer and still cant pass inspection. On the motor vehicle report i pass every subject besides the cats. The cats come up as "not ready". After trying many different types of drive cycles I ran out of ideas. I decided to try...
I got rejected after going through inspection the first time after installing new cats on the car. The reason was that the OBD report read that the cats and one other thing were "not ready". at the time I was on an SCT tune and figured either the cats were disabled in the tune, or I just havent...
Selling a brand new full tilt boogie bushing kit. Comes with everything besides bolts and grease fittings i have all bushings from upper/lower control arm, front diff, rear diff, and subframe also with the aluminum sleeves and shimming washers. Im also throwing in a gloss black billetflow IRS...
I have very bad wheel hop like alot of people do. Just out of curiousity would this kit along with sub frame bushings be enough to reduce or eliminate wheel hop? Also is this even a good kit? I dont know much about bushings but ive heard that these are the ones you would get through MM. Any help...
I have a 68 mustang coupe with a 289. Ive been having tons of problems lately but sorted alot of them out. My one problem now is starting it. It use to start perfectly fine but one day just crapped out. I than figured it might be starter solenoid since it was the original one. I replaced the...
A friend of mine has a 2006 Mustang GT. Recently driving the car lost all throttle response and got a wrench light and engine light. The cars gas pedal is completely inactive and it sputters and bogs at idle which is the only thing it can do. When checking the engine codes it read 2111 and 2104...
Not sure if this is somwhere on the forums so sorry if it is but does anyone have write up or how-to on proper wotbox installation? The yellow, blue, and green wires were easy but I didnt understand how to hook up the red and red/black wires. The instructions i downloaded from the website were...
Just recently purchased and installed a DDM tuning HID kit 9007 hi/low 55w. The problem right now is that i can't get the hi/low function to work properly. The regular lights work fine. At first i had the wiring to the stock harness plug set up so the low beams worked but the high beams would...
Recently my car has been bogging at WOT around 4000 to 5000 rpms. Normal driving and idle is fine but at WOT it almost feels like im hitting a fuel cut its like an instant loss of power. My car isnt too heavily modded ether. I have a JLT short ram intake, pypes o/r x pipe, borla stinger catback...