True, but all his weight also transfers to the rear tires... Are Mr2's RWD????
Yes they are RWD
True, but all his weight also transfers to the rear tires... Are Mr2's RWD????
Damn that was slow
arent most cars with only 320rwhp?
that was 16psi. at 17psi he ran a 12.01 and at 20 psi he ran 11.55
pretty big jump for a few psi. his turbo is out of its maps at 16psi, he needs to be running it closer to 23-25
Well the weather is getting better here but the fox is having transmission issues so that race may be delayed. I asked the SRT4 guy to race tonight but he didn't respond, I just bought a standalone for my car and finally got around to tuning with it, here is a video of a 2nd-3rd gear pull at 16psi, should be roughly about 320rwhp I think. It is still a little cold out (about 38 degrees) and thats why I spun right at the top of 2nd.
YouTube - 2ndgearpull
Pretty strong 2nd gear man!:beer:
Motor will be a .030" 302 with GT40 heads explorer intake and E cam.
Should make 320rwhp. I'd suggest going with some compression since you are replacing the pistons. Look into a better cam and intake also.
I already have the intake and the cam, i've had them for a while. Its just a temp motor, so i am not spending any real money on it.Should make 320rwhp. I'd suggest going with some compression since you are replacing the pistons. Look into a better cam and intake also.
if its broke in before i leave.Ooo if he makes that kind of rwhp that would be an awesome race for me at 16psi on pump gas, bring it Dusten :beer:
I already have the intake and the cam, i've had them for a while. Its just a temp motor, so i am not spending any real money on it.
if its broke in before i leave.
I already have the intake and the cam, i've had them for a while. Its just a temp motor, so i am not spending any real money on it.
Well atleast go with some good compression. I'd go with 10.5-11.1 if I were you.
well, the car is up and running, and pretty slow if you ask me...
oh well, lets race chris
YouTube - exhaust clip
thats a third gear pull.
run down on the new motor
Explorer intake
GT-40 heads with stock valves, 3 angle job and TFS valve springs
stock bottom end, bored .030, E-cam
24lb injectors, 65mm tb, 73mm maf, bbk cai, mac short tubes, OR h-pipe, 2.5" exhaust.
it runs 11's on a built motor and aftermarket turbo/cams/stand alone... i ****ing hope.You should beat chris but I think you will go down to the sushi sled
it runs 11's on a built motor and aftermarket turbo/cams/stand alone... i ****ing hope.
but, i could always roll out the tiller... race from a roll?
well, the car is up and running, and pretty slow if you ask me...
oh well, lets race chris
YouTube - exhaust clip
thats a third gear pull.
run down on the new motor
Explorer intake
GT-40 heads with stock valves, 3 angle job and TFS valve springs
stock bottom end, bored .030, E-cam
24lb injectors, 65mm tb, 73mm maf, bbk cai, mac short tubes, OR h-pipe, 2.5" exhaust.