I posted this post in the accufab thread so here it is again.
Well guys I don't know where to start. I took my car in on Tuesday cause the shop is doing a e85 tune. I put the new TB on and told them to run a baseline before the e85 stuff. They couldn't get to my car till friday morning cause of tuning issues with another car. They drove my car out of the shop fine and it drove onto the dyno fine. They turned it off to strap it down and when they try to start it up again it turned over twice and clunk. They tried it again and it sounded like the starter spun freely. They put the car on the lift took the starter off and it looked fine, the flywheel looked good. They took out the plugs they looked good. They try to turn the crank by hand and they couldn't. The engine is locked up. They are supposed to tear it apart on Tuesday to see what the hell is going on. My car is a 2012 with only 4500 miles on it. So hopefully its a timing chain or something simple.
Well guys I don't know where to start. I took my car in on Tuesday cause the shop is doing a e85 tune. I put the new TB on and told them to run a baseline before the e85 stuff. They couldn't get to my car till friday morning cause of tuning issues with another car. They drove my car out of the shop fine and it drove onto the dyno fine. They turned it off to strap it down and when they try to start it up again it turned over twice and clunk. They tried it again and it sounded like the starter spun freely. They put the car on the lift took the starter off and it looked fine, the flywheel looked good. They took out the plugs they looked good. They try to turn the crank by hand and they couldn't. The engine is locked up. They are supposed to tear it apart on Tuesday to see what the hell is going on. My car is a 2012 with only 4500 miles on it. So hopefully its a timing chain or something simple.