I'm in the middle of doing headers and a BMR tubular K member. The k member is basically ready to be dropped. I have a strut bar to support the motor. Wondering where you guys support it from?
In this picture, I have the stands right at the strut tower for support.
And looks like this
I would think, if I was going to support somewhere on the timing cover, the whole bar should come forward basically being right on top of the timing cover. But the body seems flimsy there.
I could use the intake manifold bolts, but I don't want to take the intake off and leave it open for a few days.
If anyone has any pictures of how they did it I'd appreciate it.
In this picture, I have the stands right at the strut tower for support.
And looks like this
I would think, if I was going to support somewhere on the timing cover, the whole bar should come forward basically being right on top of the timing cover. But the body seems flimsy there.
I could use the intake manifold bolts, but I don't want to take the intake off and leave it open for a few days.
If anyone has any pictures of how they did it I'd appreciate it.