I cannot get these SOBs loose! Anybody have any good tricks besides PB Blaster and wait? HELP!!:shrug::bash:
just a little heat from a torch is all it takes!
I don't know what all the fuss is about, me and my friend just used some Moovit and got them off from underneath the car, jack stands not a lift
I don't know what all the fuss is about, me and my friend just used some Moovit and got them off from underneath the car, jack stands not a lift
Yea i was just about to make a thread about this. I tried to change mines out and gave up due to not wanting to strip it. Ill soak it with WD-40 and use a impact tomorrow and hopefully that will do it. Is pb blaster better than WD-40?
What tools did you use to get the bolt that you are supposed to get from the top? :shrug:
Yea i was just about to make a thread about this. I tried to change mines out and gave up due to not wanting to strip it. Ill soak it with WD-40 and use a impact tomorrow and hopefully that will do it. Is pb blaster better than WD-40?
What tools did you use to get the bolt that you are supposed to get from the top? :shrug:
I was too gentle with it. Was worried about snapping the bolt.
A little blue painters tape on a swivel will hold it straight until you need it to swivel. Good little trick.
I know it's an easy job once those bolts are out. I did it on my 2008. The 2011 seems much tighter.
PB blaster penetrates, wd-40 just displaces water, but wd should work regardless,
I used antiseeze on reassemble as well :beer:
It's a 15 min job once those damn things bust loose!