Haven't gotten much work done lately. I re-tore my ACL and had knee surgery so I have been pretty slow moving around. Just been collecting wiring diagrams and saving some money for more mods...
Getting it ready to go back together
L wiring harness getting ready to install in black truck
This project is starting to suck. TOO much fabrication and not enough fabrication tools available in my garage....
one wiring harness completely ran
I decided there was no way I was going to try and swap the PATS electronics out, so I just swapped the whole stearing column
Got the vents in, along with the main wiring harness. Too bad I can't remember for the life of my where half of the wires go to.
Got some other work done in the engine bay, but it just disappointed me more. I am discovering a couple bolts that snapped while I was tearing it down and my drill was dead so didn't even mess with trying to get them out. Also swapped brake pedals, tried to swap gas pedals...but they mount different. looking forward to other stuff while I was bored and noticed that I have a lot of missing mounting holes from truck to truck.
Hopefully tonight I will get the engine bay completely wired and start putting accessories back in it.
Really hated to hear about your L. The good thing about what your doing is you will know everything about it and you can say you built it. Hop to see it going soon. GL with it.