Recent content by jordanvraptor

FS 2.93 pulley and misc Sold my Cobra and decided to clean out the garage. Feel free to make reasonable offers. Amazon Racing BF 2.93 pulley. $40 shipped Stock shifter. Make offer. Mustang emblems. Make offer. Wheel lock key. Make offer. 2.93...

I think it is a pulley in the secondary drive belt loop. I had the main serpentine belt off and started the car and still had the noise. Vid was taken in my garage with me just revving it to 2-3K rpms. Car has stock exhaust with drop in KN filter. Car seems to work fine, just noisy like I'm...

My clutch cable snapped at the quadrant after about 50K miles and I just bought a new OEM from Ford part number 2r3z-7535-aa. I have a Fiore microclick firewall adjuster and quadrant. The part I just got from Ford has the firewall mount and plastic grommet with hooks thingy still attached to...

sold

I did lose, but I bet I surprised him on the launch. :-D I picked a bad day to miss 2nd gear as well... :nonono: He did a best of 11.9 @ 122 that night. Against me, he did a 12.5 @ 117 mph. A buddy of mine in another 03 Cobra actually beat him across the line but lost to him on the ET...

I used to have a JLT CAI and liked it fine until a little accident while repainting it... :cryying: So for a time I went about looking at different intakes and finally bought a KN FIPK. Well, I had emailed Jay about converting the CAI tube to the RAI setup and he was very helpful so I went...

anyone have one? Mustang exhaust doesn't... :mj:

Went to the dyno today and tuned with the predator. The tune seems to stumble and the AF ratio dives for the ten mark at around 4500-5000 rpms. I noticed from the datalog, that around 4500 is where the MAF voltage reads about 4.6-4.7 and it went to 4.9 today at around 6000 rpm. I wonder if...

Looking for a good tire to go on the front wheels only. Want to get maximum tread life. Low price would be a plus. Any ideas?

Terminatrix had some warranty work so I had to return her to almost bone stock condition. Work is done so I am proceeding with a different buildup. I put the Kenne Bell 2.75 press on pulley on with a UPR tensioner idler pulley and a 74 inch Gates belt. That was coupled with the stock airbox...

Originally posted in Modifications by mistake.... Shortly after putting on the 2.75 pulley, my car is throwing two codes on the SES. The first is: P1000 OBD Systems Readiness Test not complete. This one doesn't trigger the SES light though. The second one does trigger the SES light and...

Shortly after putting on the 2.75 pulley, my car is throwing two codes on the SES. The first is P1000 OBD Systems Readiness Test not complete. This one doesn't trigger the SES light though. The second one does and comes back after I clear it. P0401 Exhaust Gass Recirculation Flow...

Thought this was interesting.

From what I understand the boost bypass system is a valve that opens and closes depending on throttle position and is why we aren't at boost 100 percent of the time. Is this a on/off type valve or is it variable according to conditions. If it is variable, what exactly controls how much boost...

Looking to do a serious power buildup over time. Figure I'd start with a 3" catback system. Any have the rolled tips like the Borlas? Also, are there 3" O/R pipes or is that as much of a factor. I don't plan on headers as of this moment.