Here is what I installed:
All urethane front and rear (I mean EVERY one)
26 spline input on tranny
Centerforce stage III and Fidanza Aluminum Flywheel
Detroit Locker
Level 5 Axles
Billetflow Differential Housing Brace
MM full subframe connector
MM 4-point K-member brace
MM strut tower...
I am ready to install the new MAF on my car. Does this MAF have a specifc Transfer Function that I can load in my Racer Pro package to properly tune the fuel curves?
Any help would be appreciated
I recently installed a 2.93 pulley and Crower Stage 3 cams. I also have a custom Predator tune from James.
I experience a very slight hesitation when I accelerate, especially in the 2000 to 3000 rpm range. Sometimes, it is accompanied with, what sounds like, a subtle backfire. It resembles...
...but I just couldn't stand it any more... :shrug: :shrug:
The "Boost Bug" bite was too much; so I installed my 2.93 and idlers earlier this evening. Right now I'm using the standard pulley tune until James gets me his "magical" custom tune.
I got into it once...MAN, what a rush...
1) Have you noticed any driveability issues, especially below 2500 rpms?
2) How are the accessories (i.e. air conditioning, charging) at the lower rpms.
3) At what rpm does it idle?
4) What is your overall perception of these cams.
I apologize for all the survey-like questions; I am...
Performed a search to no avail...therefore...
Has anyone uprgraded the differential in these cars? I am considering the Trac-tech C-Locker; this appears to be the 8.8 version of the 9" Detroit Locker. I am considering this upgrade along with the DSS Level 5 Axles and the MJ Brace.
The...
I was in Robbinsville, North Carolina, on Friday picking up some supplies for camp and noticed one Redfire '03/'04 Cobra and several '99 and '01 Cobra gathered at a local gas station.
I was just wondering if anyone on this site happened to be one of those.
It is time for a plug change. I wanted to perform some other related upgrades, as well; but I cannot find any information regarding performance plug wires and coilpacks. Doe anyone make either?
Will you post your A/F readings for both Open-Loop (WOT) and Closed-Loop (cruising) mode? Charts would be appreciated.
I want to compare real-world readings as opposed those acquired on a dyno.
Thanks.
I can't seem to get it to work. Is anyone else experiencing this? The Predator displays that I have 4.10s, the computer still does not compensate.:shrug:
I am just now getting around to installing my AfterBurner and have a quick question. In the manual, it states that I am to splice into a red/pink wire connected to pin 63 in the harness. However, I don't see a red/pink wire at pin 63. Am I to give priority to the wire color or the location...