On february 20 i got into a pretty bad accident. It was 1:40 in the morning on a friday night. I had been hanging out with some friends and was taking them home when we came around the corner at about 60-65 when i was looking at a trucks headlights in my lane. All i could do is jerk the wheel to...
okay. So i have been building a budget 351W for my 95.
The 351 is started with a 69 motor out of a Mach 1. Factory hp/tq numbers for that motor is 290/385.
The motor has been bored .060 over with factory heads with a 9 angle valve job with light port work and a shaved head and deck...
i am in the process of building a 351 windsor with fuel injection. So, lets see all your fuel setups. (tank, pumps, lines, rails, everything) :thumbsup:
i decided that since everybody else was going bigger with their wheels i would switch it up a little bit and go smaller. I was kinda looking for that old school look with stamped steel wheels. sort of like a road course car/ nascar tire setup. I am looking into the cragar 15x8 wheels and was...
i was wondering if anyone has ever installed a two wire single speed fan in one of our model cars. I do not want to run an extra switch. I would like to know if i can splice it into two of the three wires for the original plug. I know which one is the ground, but do not know which power wire to...
i am running a zex 75 dry kit bought colder plugs the autolite 24's in a 5.0 gapped to factory specs of .054 and i get spark blow out. what should i re-gap them too.
please and thank you.
Richard
yes i searched. no info found for 5.0
i am looking for the company that makes the panels with slots cut in them for switches that replace the stock ash tray in a 94-95 i have found something similar for the newer vehicles just not for my console style.
thanks,
Richard
i have a 91 Eclipse GS that i am wanting to sell or trade. 2500 obo for sale or will consider almost anything that gets good mileage. the car has the 2.0 DOHC 4G63 non turbo. 6 Bolt motor. 131,XXX miles new altornator, battery, brakes, master cylinder, all belts minus timing belt. motor runs...
its a almost full bolton 95 GT. My girlfriend got probably my worst run of the day on the camera, where i hit rev limiter and fuel cut before second gear. anyways here it is before it goes to the shop on friday for a gear install. it has stock 2.73 in the vid and goin in for 3.73.
i had the...
1991 mitsubishi eclipse GS
130,000 miles
2.0 liter 4G63 non turbo
5 speed
bone stock
interior is almost perfect, just one spot on the dash where it meets the driver side door, new headliner
exterior has a ding on the passenger door and the paint is oxidizing on the spoiler, small scrape...
this is the second stock piece that has gone bad. so im in the market for an all steel/aluminum. looking at the pioneer. but what is the imbalance weight for the 1995? 50 oz or 28.2 oz?