I go to get my car inspected today at the local Speedy Oil. The car has been off the road for a while. Speedy is right down the street and my sticker was almost a year out of date. They tell me no problem but will be a little while. I wait about twenty minutes when the tech comes and gets me. He...
In the process of replacing my P1Sc plumbing I found out my mass air sensor was cracked. It was a 80mm Lightning. I got a 90mm Lightning for a lot cheaper than the 80mm. The dealer wanted almost $300 and a core. My problem is the size difference in the meter and my plumbing. The tubing is 3 inch...
I am thinking of selling my Cobra. It needs a bunch of work and I haven't driven it in a long time. So it basically sits in the garage and cost me money. Most of the stuff that needs to be done is minor. Rust on the bottom of the doors,alignment,Procharger plumbing needs to be painted or powder...
Are there any alternatives to the factory auto lock hubs. I have one bad hub and my local dealer quoted $298 for one hub. That seems a little bit ridicules for one hub.
Thanks
Ed
My cobra had been in a accident a few years ago. The insurance replaced the intercooler for me. It was not the same as the original one. I guess ATI changed the design. I did not like the way it was in the car. I looked like it was at an angle. While I was trying to get my 03 bumper cover to...
My Cobra has started to have a hanging idle. When I depress the clutch the idle stays at 1600-1800 for a minute or two. I have replaced the IAC with no change. Any one have any suggestions?
Thanks
Ed
Hello all,
I am looking to lift my truck to put 35's under it. It is a 01 F250. I am leaning toward the Fabtech 5.5" kit. Does anyone have any experience with Fabtech kits. Opinions are welcomed
Thanks
Ed
Does anyone know if it is worth it to smooth out the roughness on the inside of a upper manifold? Mine will be off the car and was thinking of smoothing it out. Was wondering if anyone else has done this.
Thanks
Ed
Has anyone installed one of these on a 99 or newer cobra? I have attempted to install mine but it does not look like it is going to line up. Thanks for any info or advice.
Ed
Does anyone have copies of direction sheets for the Kenny Brown Super subs,matrix braces and jacking rails. I've had these pieces sitting in my garage for a long time. I am having them installed on Friday and the shop would like copies of the instructions and I can't find mine since I moved...